SAMSON FLYING CAR FORUMS A BIG HIT AT SUN ’N FUN! - April 20, 2021 Samson hosted 3 Sun ’n Fun forums last week, entitled “What’s all the hype about Flying Cars?” Quite a few Switchblade Ambassadors...
SILVER EXHAUST FOR BLACK MOTOR - April 16, 2021 Our exhaust pipe came back from the coating shop where a ceramic coating was applied both inside and out to keep the temperatures down in the engine...
ENGINE POWER SHAFT COMPLETED - April 14, 2021 This shaft takes power out of the engine, and transfers it to the propeller through a chain drive gear reduction unit. We opted for a chain drive, as it...
ENGINE POWER SHAFT COMPLETED - April 9, 2021 This shaft takes power out of the engine, and transfers it to the propeller through a chain drive gear reduction unit. We opted for a chain drive, as it...
PROP SHAFT TAKES SHAPE - April 7, 2021 The first of two shafts we just received was mated up to other parts and made into a sub-assembly ready to be installed in the vehicle. You can see what this...
WE RECEIVED THE LAST TWO PARTS!! - April 5, 2021 The last two of 256 parts needed for the engine change-over were received, and will be made into sub-assemblies prior to installation on the engine...
FINALIZING SUSPENSION HARDWARE - April 1, 2021 Nick Yakola is swapping out some of the hardware for the rear landing gear. Nick had earlier installed the limit straps to prevent the landing gear to...
ELECTRICAL CLEANUP - March 29, 2021 Phillip Mikula, Electronics Tech at Samson, has been working to clean up the electrical wiring in the cockpit, as we found we could remove much of the wiring...