The exhaust pipes were welded and installed on the engine in the engine bay. The crinkly surface is aluminum and insulation to control exhaust heat in key areas. Still to be installed is one small...

The exhaust pipes were welded and installed on the engine in the engine bay. The crinkly surface is aluminum and insulation to control exhaust heat in key areas. Still to be installed is one small...
In getting everything set up for the Samson 3, we spent a few days simplifying things, as there was a lot of wiring in the engine bay that just didn't need to be there. The Electrical Tech (Phillip...
Thanks to all who put in a guess on our Facebook contest! It was tough to judge because we didn't give you a point of reference. Congratulations to Terry Roberts, who guessed 30 lbs even, which was...
Another big milestone for the new engine installation was made today when the Assembly Team finished mounting the new gearcase from SkyTrax to the Samson 3 engine. You can see in the image above the...
One of the major portions of getting this new engine installed was to create a new driveshaft linking the engine/gearbox to the propeller. We didn't mind having to re-do the prop drive shaft, as it...
Usually, mechanical things are seen as functional rather than aesthetic. We would like to make the case that the new gearbox from SkyTrax is a beautiful creation. This gearbox bolts to the engine...
The modifications to the rear cabin bulkhead are in their last stages. In the image below, Composite Tech Bart Long is applying aircraft adhesive (Hysol) to the last modification, which is to give...
Electrical Tech Phillip Mikula recently completed the engine wire harness, so it can be easily installed in the Switchblade engine bay when we're ready. You can see the MoTeC ECM (Engine Control...