Events

ENGINE WIRE HARNESS – November 29, 2021

ENGINE WIRE HARNESS – November 29, 2021

Electrical Tech Phillip Mikula recently completed the engine wire harness, so it can be easily installed in the Switchblade engine bay when we're ready. You can see the MoTeC ECM (Engine Control...

read more
MOVING CARBON – November 24, 2021

MOVING CARBON – November 24, 2021

We are moving parts of the rear bulkhead around to clear the new exhaust pipe routing that the new engine requires. Carbon is sensitive to heat, so we have to give heat sources enough room to make...

read more
WHEELS ON THE BUS – November 22, 2021

WHEELS ON THE BUS – November 22, 2021

The new engine has been mounted on the tube frame and we had removed the tube frame from the vehicle to gain better access to the engine and faster work getting the electrical, fuel, and intake air...

read more
NEW HUBS TO ROLL FASTER – November 1, 2021

NEW HUBS TO ROLL FASTER – November 1, 2021

Still waiting on engine parts, so we replaced the hub bearings on the rear wheels to help the prototype roll easier and with less friction. We had noticed on our last few runs that there was more...

read more