In the last post we described leveling the main wings. The next step of mounting the tail to the body is to put the tail horizontal wings on a structure that can be slightly adjusted up or down. In...
We are mounting the tail to the vehicle after reinforcing strengthen or support (an object or substance), especially with additional material the tail structure to make it stiffer. The way...
The roof scoop for the Switchblade flying sports car is being made by first 3D printing the mold, which is in 2 parts. Both halves are being 3D printed at the same time. Once the mold is completed,...
We are 3D printing this mold for a part that will be made of carbon fiber. This mold is for the lower half or the upper section of the roof scoop. Contact Us
Assembler Sean Bliss is shown working on the steering wheel to take some play out of the system for better pilot feel. Having a smooth control wheel operation is important, especially for making...
Engineer Tanner Vaughn is getting his talented hands dirty putting together the rear suspension drop test components for an upcoming test. The drop test for the rear suspension was done and passed...
Lead Engineer David Nobles examined the rudder fly-by-wire mechanism just tested to ensure that there was no evidence of failure, premature wear, scarring of the shaft, or other outness. The rudder...
The Switchblade flying sports car fly-by-wire rudder system was tested and passed earlier during endurance testing, but a tear down showed that there may be an issue with a shaft connection. We...