We are moving parts of the rear bulkhead around to clear the new exhaust pipe routing that the new engine requires. Carbon is sensitive to heat, so we have to give heat sources enough room to make...

We are moving parts of the rear bulkhead around to clear the new exhaust pipe routing that the new engine requires. Carbon is sensitive to heat, so we have to give heat sources enough room to make...
The new engine has been mounted on the tube frame and we had removed the tube frame from the vehicle to gain better access to the engine and faster work getting the electrical, fuel, and intake air...
We thought you might like to see how the final installation of the curved piano hinge looks. This image shows the silver piano hinge facing forward on the rear part of the ducted fan section. You...
The flight simulator projectors produce a lot of heat, and we installed cooling fans to handle that. The fans were a bit noisy, so Ronald Forseth, who is finishing the simulator work, 3D printed fan...
Here you can see the 3D printed mount with silver ducting attached to it. The quiet computer fan is being held in a similar position to where it will ultimately be bolted to the mount, once...
Actuators move things, and the flaps are the movable wing parts just next to the body. The flaps are moved from an upward position to a downward position for take-off and landing, and both left and...
Still waiting on engine parts, so we replaced the hub bearings on the rear wheels to help the prototype roll easier and with less friction. We had noticed on our last few runs that there was more...
With the propeller spinner trimmed, it is now mounted with the hub and propellers on the frame so the assembly can be spun to check and adjust to get a true axial rotation of the spinner. If it...