We just had to show you a little glamour shot before we get back into more testing today. The new paint on the nose cone and front hatch gives a cool contrast to the side panels and door. But please...
After months of extensive tests and quite a few modifications and fine-tuning, the Switchblade has passed both the engine cooling and acceleration requirements needed prior to flight testing! Our...
Nick Leonard - Switchblade Owner and aircraft builder - flew up from California in the RV10 he built, to update the Dynon display. Nick is shown here updating the current system software, as well as...
After we repaired the engine water pump, we ran the Switchblade flying sports car outside to check for leaks. It proved to be in perfect condition, so well done to the Team! Now we are putting the...
This is a mold for a portion of the radiator duct. The mold was 3D printed and then body-worked for smoothness, which gives it this unusual pattern. This is a future part that we plan to incorporate...
The wings are the first part of the Switchblade to get a new look with this dark grey. Our Ferrari Red vinyl wrap was showing some wear and we couldn't risk it coming lose during flight testing. Sam...
One place sometimes overlooked as a way to improve the cooling of the engine is the air intake. We had our air filter and intake tubes near a side inlet that let cold outside air in, but the intake...
The work to close the gap between the duct and the propeller tips aided our recent taxi testing. You can see the prop tip gap in the image below. (We took it down from 1/2" to 3/16".) We also...